04-10-2016
07:17 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
04-10-2016
07:17 PM
I think the same answer would apply to this question as well, maybe this will make the question more clear.. I want to engrave this logo on a part. But I dont want to engrave the outline, I want to remove the mateial inside the letters, say 0.010in deep. When I select 2d pocket it wants to machine around the entire part, leaving the area selected untouched, but what I'm looking for is to simply cut out the letters compleatly as opposed to an outline.
Fusion