Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
mattdlr89
in reply to: Anonymous

@Anonymous 

 

It should be possible without the extension. Either by drawing a sketch or being selecting in a different way. 

 

When you select two faces for X and Z you will get a conflict. Ideally you need to select a face then an edge. 

 

I got the following by selecting the face for the X-axis (circled in red) and then for the Z axis I selected that edge as highlighted by Fusion. Is this what you are after? This doesn't require the extension.

 

mattdlr89_0-1620640975981.png