@donald.kunath, sorry for the delay, I had like 3 submittal dates all within 4 days of each other. I had to table my Fabrication development until after my last one went out yesterday.

Been chomping at the bit for 3 days dying to test this.

Thank you sir! That was it!

I noticed all those "Bend" options in the individual buttom properties were blank. I had to fill those in.

I am going to make a pass through all my Services making sure those are set.

Follow up question... I saw those needed set to "Bend" or "RedBend" or whatever. I did not see one for Tee... I did see a couple that looked like they were for reducing tees however. Is there a name that's not readily apparent for a tee that I should point them to?