Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
JamieSENG
in reply to: MechMachineMan

I realise my limitation was that the code ran through all open drawings but didn't physically go to the next, hence why I kept getting the same file throughout. For the time being, I'm just going to use the code as is. Seems more trouble than it's worth trying to fetch the iproperties.

 

You did mention before that you would need to "call view.Document.Activate for every new document during the loop"

Would this activate each drawing to apply the rule?

 

If so out of curiosity how would you go about doing it? I sense there could be an issue with the loop going back over the first?