05-18-2015
01:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
05-18-2015
01:19 PM
Hi All,
Is there a way to put a folding dimension in the bend note of a flat pattern.
I.E As well as the usual Up/Down, Angle ,Bend Rad etc. A Finished dimension of a flange from
the edge of the sheet.
Thanks
Solved! Go to Solution.
07-21-2016
08:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
07-21-2016
08:14 AM
Hi Irfabs,
See this link:
I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com