04-18-2022
03:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
04-18-2022
03:23 AM
Hello,
I have created several custom command which work in Drawing, Part and Assemblies. And I have use OnEnviromentChange event to enable & disable those. But while doing this Dynamic simulation and Stress Analysis was disable automatically. When I'm removing this event then both are enabled.
Can anyone help me to resolved it?
Regards,
Jatin Devaiya
If a response answers your question, please use ACCEPT SOLUTION to assist other users later.
Also be generous with Likes! Thank you and enjoy!
Jatin Devaiya
If a response answers your question, please use ACCEPT SOLUTION to assist other users later.
Also be generous with Likes! Thank you and enjoy!
Solved! Go to Solution.