02-11-2022
05:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
02-11-2022
05:15 AM
I know that the:
Parameter("CompName1:1", "ParamName1") = Value
will (normally) access whichever model state that the named component is currently set to in a top level component, but I have not tried it while using MakePath yet. Even that was a little unpredictable at times though. I don't know if they have all the bugs worked out of the new ModelStates yet. Then their lack of detailed documentation about their 'iLogic only' snippets doesn't help either.
Wesley Crihfield
(Not an Autodesk Employee)