Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
WCrihfield
in reply to: theo.bot

Yep.  I did the same just after posting.  Created a similar model, created the drawing with 5 views, one of which was a section view sliced down the center.  No matter how I set every possible setting, it would not put the center lines in every location I wanted.  This all seems very familiar too, like I've dealt with it before sometime, but I can't find where or how right now.  I have even created centerlines/centermarks on rectangular punch features in drawing views of parts before, but that was something planned for, not for general use.  We would most likely have to do a bit of a deep dive into the view's geometry objects, checking what features made them, then maybe using centerline bisector's or similar.  That seems a bit too inefficient though for most cases.

Wesley Crihfield

EESignature

(Not an Autodesk Employee)