Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
in reply to: rikard.nilsson

Hi Rikard,

 

Thank you, I have found this piece before too.

Dos not work, I like to make it via iLogic.

 

I have an assembly, i iterate through each part and send each part his relative XYZ coordinates and save them in the part parameters. I will need them for a later operation.

So this works, but I will also need the Angles relative to the assembly origin, and here it starts to be complicated.

 

In the Forum I only can find posts dealing with the manipulation of this matrix, I "only" have to read em out.

So i my view the approach from @MechMachineMan is the most logical I have found so far, but it needs to be changed.

 

Thanks a lot

 

Simon