Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
moraesorlando
in reply to: fullevent

Helo @fullevent !

 

Thanks for generate a code to iLogic, I am new in Inventor programming and not familiar with VBA inside Inventor.

 

So, I tested the iLogic code but I didn't succeed.

 

Following, the steps I past through:

 

1 - I have run the code and a dialog box were shown

 

2 - I have put the numbers 2020-101

 

3 - A dialog box for browse the files was shown

 

4 - I have indicated the destination folder to paste the files

 

5 - An error message were shown

 

Please take a look in the attached file with illustrations of each step.

 

Thanks and best regards,