Undercut Problem
No aplicable
02-15-2018
07:12 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hello everyone! I have a problem with a 3-axis cutter. I would like to make a very simple processing, a sort of undercut. To understand this, I have my zero point set in (0,0,0) (x, y, z). The piece goes down in height (0,0, -5) and this side must not be worked. Then the piece continues: (0, -5, -5) (0, -5, -6) (0, -5, -7) I do not know if I have explained myself, but it is similar to an edge, a step, an edge. Here, every time I try the tool I enter the piece. Does not recognize the step! Although I always give it the boundary surface. How can I do?
