- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
How can I make a trochoidal path for rouging that opened channel ? I've tried to make with curly corner but is not ok.
¡Resuelto! Ir a solución.
The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.
How can I make a trochoidal path for rouging that opened channel ? I've tried to make with curly corner but is not ok.
¡Resuelto! Ir a solución.
Hi @grosucsm,
Thanks for posting on forum. Vortex for open pocket seems not possible.
To trochoidal mill an open pocket or side in FeatureCAM using the vortex strategy, do the following:
Note: Changing the plunge point to a point outside of the stock boundary may be necessary if a ramping entry move is not desired.
Thank You.

Thank you for your fast answer.. but when I am selecting Vortex strategy I can't select the Plunge point.
But.. it seems to do it in the right way.. Thank you !