Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Tool path off of geometry

Anonymous

Tool path off of geometry

Anonymous
No aplicable

I have some slots that need to be cut on the face of a part.  The slots are 1.5 mm wide and .3 mm deep.  I want to run a 1.5 mm end mill down the center of the slot to finish it.  I created a curve along the edge of the slot and wanted to run the cutter on the left side of the curve.  I can not figure this out.  Can someone help me with this?  So how do I drive a cutter on the left side of a curve for 2D machining?

0 Me gusta
Responder
Soluciones aceptadas (1)
422 Vistas
2 Respuestas
Respuestas (2)

Anonymous
No aplicable
Solución aceptada

You should be able to do that with a Side feature.  But if you just want to run a centerline path, you could also create a curve on center and use a simple groove.

0 Me gusta

Anonymous
No aplicable

Thank you

0 Me gusta