Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

tool constantly lifting out of material on MF files

Anonymous

tool constantly lifting out of material on MF files

Anonymous
No aplicable

I have tried everything I can think of, and no matter what I do, when I create an MF file, the tool is constantly  lifting out of the material. it will take a small cut lift up to the rapid plane even though I have retract to plunge clearance marked. I have used minimize tool retract it still does it. I have also tried everything under the milling tab. At this rate what should be faster to run multiple parts is taking three to four times longer per part than if I just ran them individually. Anyone have any ideas?

Okay so I tried to attach the MF file but apparently you can't attach that file type go figure so I don't know how to show how it is programming it. I have however attached the FM file as of the last try but like I said I have tried a lot of different scenarios without any luck.

0 Me gusta
Responder
Soluciones aceptadas (1)
549 Vistas
4 Respuestas
Respuestas (4)

zlancy244
Enthusiast
Enthusiast
Solución aceptada

Set your vortex z lift to .003. Thats the backfeed micro-lift. Its a non cutting move. Hope that helps.

It is in the milling tab

Anonymous
No aplicable

Okay I was trying to go by what the help files were showing and it looked like the larger the Z lift the less it would lift out. I must be misinterpreting what the help files say or they are backwards.

0 Me gusta

Anonymous
No aplicable

Oh and thank you so much it worked great

0 Me gusta

zlancy244
Enthusiast
Enthusiast

Great, glad I could help.

0 Me gusta