Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

HAAS SL-10 Post not outputting Feed into the code

f.k.noyes
Observer

HAAS SL-10 Post not outputting Feed into the code

f.k.noyes
Observer
Observer

I'm trying to program my HAAS SL-10 lathe using FeatureCAM but when i try and simulate the code on the lathe it gives me an error saying it hasn't been given the feed rate. when looking at the g-code its right and will either skip the feed rate or say "F0." as the feed rate. I've tried looking in the post editor but i can't find what to change to fix the problem.

 

Am I doing something wrong while programming or is it a problem with the post processor?

 

Thanks

0 Me gusta
Responder
Soluciones aceptadas (1)
541 Vistas
4 Respuestas
Respuestas (4)

bhorstTGM48
Collaborator
Collaborator

I beleive that the.FM file you uploaded is the temp file? It is only 1k in size. 

0 Me gusta

f.k.noyes
Observer
Observer

Sorry about that. I've uploaded it again.

0 Me gusta

chrisdavid605
Contributor
Contributor
Solución aceptada

The word formatting is not setup for less than 1.

Go into the post > cnc info > word formatting > find feed/rev > click the underlined text > change the metric format from 4.0 to 4.4, this will give you 4 places after the decimal. Your feed for min is setup the same if you want to change that just edit that word the same as the other.

0 Me gusta

f.k.noyes
Observer
Observer

Thanks for the help. This worked perfectly!

0 Me gusta