FeatureCAM Probe HAAS

[Anonymous]

Hi! We just bought a new HAAS VF4SS and we are trying to use our Probe with FeatureCAM Ultimate 2020, but after running the simulation we don't see any gcode. Is this a post processor problem? If that's the case, is there any sample or generic post processor?

[kelbie.ockey]

Your post does need to be set up for probing cycles to output from FC.

If you are purchasing your software, services, and posts through one of our reseller partners, I would reach out to them and they can facilitate the necessary edits you will need.

If not, the best method to get the ball rolling with ADSK would be to create a new support ticket requesting these edits to be made to your post.

Let me know if you have any further questions.