FeatureCam/PartMaker/PowerMill Help
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Ok guys,
New to FeatureCama and PartMaker. We've used Inventor HSM for a number of years and primarily use Siemens NX.
That being said our Lathe Dept. has been doing all the programming in PartMaker for our turn, swiss and mill-turn equipment. Sadly the sole programmer for that dept./software has passed away and I need to get my department trained up in this software(s). so I have a few questions:
1.What software is best to move forward in out of FeatureCam, PartMaker or Powermill?
2. I see all kinds of videos online showing the machine simulation in these software's, but I have yet to figure where to acquire the simulation files and how to get them setup. Where and how do I get them setup?
3. Are any of the files compatible with each other? (Open PartMaker Files in FeatureCam or Powermill)
