Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Face groove

brian_p1
Advocate

Face groove

brian_p1
Advocate
Advocate

Have been trying to program this face groove using the face turn feature works up until the point of it plunging into the stock full depth around the curve then retracting back to carry on the roughing.......no idea why it would want to do this, any ideas?

Have also tried as a groove from curve but it doesn't like that either

0 Me gusta
Responder
Soluciones aceptadas (1)
431 Vistas
1 Respuesta
Respuesta (1)

brian_p1
Advocate
Advocate
Solución aceptada

Found out that if you tick the skip wall pass on the turning properties page than it will not plunge through the component, no idea as to why it want to do the wall pass when in the middle of a roughing cycle