cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

If connectors are used to snap an asset into position in AutoCAD, the z-elevation of the connector should set the elevation of the placed asset.

If connectors are used to snap an asset into position in AutoCAD, the z-elevation of the connector should set the elevation of the placed asset.

If connectors are used to snap an asset into position in AutoCAD, the z-elevation of the connector should set the elevation of the placed asset. Currently the connectors only position the asset in the X,Y position when used in AutoCAD and the default elevation snaps to the floor or Z0 position.

1 Comment
paul.colemanCHT7Z
Contributor

This is quite disappointing it isn't already built in. Actually, defeats the purpose of utilising AutoCAD into the workflows. And this idea is 4 years old!

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Autodesk Design & Make Report