All,
Good afternoon! I was alerted to this by a customer and wasn't sure if there was a way to alter this behavior. As I demonstrate in the video below, if you create / edit an assembly level sketch on a Factory Layout and then exit that sketch, the Selection Priority remains at the sketch level. This forces users to have to switch back to the Component Level Priority in order to modify assets. However, in a standard Inventor assembly, after exiting the sketch environment the Selection Priority switches back to Component automatically. Is there a way to make these behaviors the same? Not a huge deal, but am just curious. If you have any questions, please do not hesitate to contact me. Hope all is well and have a most blessed day!
Peace,
Pete
Just a guy on a couch...
Please give a kudos if helpful and mark as a solution if somehow I got it right.