Design Line - Hanger Fill places too many Hangers due to Fittings within the Run

[Anonymous]

Is there a way to have Design Line start the fill of hangers, based on horizontal changes in direction (Bends only) and ignore Tees, Thread-o-Lets, valves, etc. that are in the same run?

[davidronson]

Not that I'm aware of, it sees the branches as a change of direction so it is throwing in the Before/After. I would like to see this posted in the Ideas Station, if you post it there I will give it Kudos.

[Anonymous]

Sounds Good. I'll post it there. We'll see if they do something with it.

Sincerely,

Eric Botts | Detailer
Pan-Pacific Mechanical
1205 Chrysler Drive, Menlo Park, CA 94025
P: (650) 561-8810 | F: (650) 561-8811 | C: (916) 796-8103
ericb@ppmechanical.com | Pan-Pacific Website| Please Contact Us
[cid:image003.jpg@01D2805B.3A3EF730]

________________________________

This e-mail, including any attachments, is the property of Pan-Pacific Mechanical and is meant only for the intended recipient and may be a confidential communication. If you are not one of the named recipients or otherwise have reason to believe that you received this e-mail in error, any review, use, retention, dissemination, distribution, printing or copying of this e-mail is strictly prohibited. Please notify the sender immediately of the error by return e-mail and please delete this message from your system. Thank you in advance for your cooperation.

[Anonymous]

Dumb question. How do I place it in the "Ideas Station". Sorry, new to this forum.

[Anonymous]

I figured out how to do it. Thanks.

[Anonymous]

Just added to Ideas. Also, check this one out in the ideas section and let me know what you think.

"Lisp or Script for Stretching Hanger ATR to Global Z Elevation"