Changing the default setting for a branch take off in the design line

[Kenny_Maciver]

Hello,

Just finding my way around Fabrication CAD MEP. When using the design line the default circular fitting for a branch take off is a curved boot (TBS). I would like the default setting to be a Pressed Tee (TCP). Is there a way in the set up to achieve this?

Many thanks in advance

[nathan.chapman · Accepted solution]

Go to the service you are using to fill the design line and add/change the button mapping for Bend to point to the code you have on the TCP button.

[Kenny_Maciver]

Very helpful. Many thanks