3D PRINTING EXPERT PLEASE!

[Anonymous]

Hello! I was wondering if you could 3D print on an already 3D printed product. For example I 3D print a box from PLA and then after it cools off (or not? not sure) I put it back in the printed and proceed to 3D print some other elements on it also from PLA. is this possible? can it be done?

[matthewweake]

This is really the wrong forum for this.

Depending on the material and printer it is sometimes possible. You do get a weak layer where the new joins the old so don't expect it to be very strong.

[Anonymous]

thank you! any suggestions on which forums I should post this to?

[matthewweake]

I would look for forums associated with the printer or process you are using. 

This forum is about Mechanical/Electrical/Plumbing (MEP) using Autodesk Fabrication products.