Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Manual solder paste

Anonymous

Manual solder paste

Anonymous
Not applicable

Hello, I want to add manual solder paste to my board. How can I do it ?

 

The idea is I want to add a RAST 2.5 connector as seen below. For the moment, I had the wire at top layer but the board manufacture told me that there will be a varnish layer and the RAST connector will not connected. So he told me to add a solder paste like SMD component. I know that tCream layer is for the solder paste, but I don't know how to add it manually. 

Thank you in advance @!

 Rast-H-cti.jpg

0 Likes
Reply
Accepted solutions (1)
786 Views
1 Reply
Reply (1)

Yura.Ivanov.VLuki
Collaborator
Collaborator
Accepted solution

@Anonymous  написал (-а): I know that tCream layer is for the solder paste, but I don't know how to add it manually. 

Draw as usual - lines, circles, rectangles by selecting a layer tCream, bCream.

0 Likes