Message 1 of 17
How to fix red circle dimension error in Eagle

Not applicable
06-04-2017
08:00 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I am new to Eagle. I am not an electrical engineer, but I an trying to learn.
I am creating a 6 layer board for my circuit. However I ran into this dimension error where I have red circles around all of the pins. I don't know what to do exactly, because these are the dimensions of the components, so I can't change them.
How should I go about fixing this?
Thank you for your help.
-Cole |