Bug report: Entering no signal name crashes the whole program.

[yscheer]

Entering no signal name in inspector at a ripped up trace crashes the whole program. Could not find a bug report page, so i'm posting it here.

Steps to reproduce in board editor.

- Rip up a piece of an existing trace.

- Click on a left over piece of trace to edit it's settings in the inspector

- Clear the signal name in the inspector tap.

- Hit enter to apply.

- Click yes on the confirmation popup.

- Crash

Using version: v9.5.2 on Windows 10 version 21H1 (Build 19043.1466)

Attached a chrashdump.

[jorge_garcia · Accepted solution]

Hi @yscheer ,

I hope you're doing well. I can reproduce this crash, I'll report it to the developers. Thanks for bringing it to our attention.

Best Regards,