Visibility when using Show cmd on a Net signal

[noelQUDAY]

Is it possible to adjust the visibility of Net signals when using the "Show" command in the schematic editor? The old EAGLE v7 used to clearly highlight the selected net signal and I would like to get that usability back. Thanks for the help. 

[noelQUDAY]

Example, this is the old EAGLE behavior:

And the current EAGLE behavior doesn't do this (at least not by default).

[jorge_garcia · Accepted solution]

Hi @noelQUDAY,

I hope you're doing well. Go to Options > Set and adjust the highlight sliders and play with high contrast mode. I recommend that you highlight something before going to the Set dialog that way you will be able to see the changes real-time.

Let me know if there's anything else I can do for you.

Best Regards,