I would like to insert a dynamic block into an acad table with specific different visibility state.
Is this possible, I don't see an option in the properties of the table cell.?
I would like to use this for blocks that are used for legends.
Thanks
JL
In order to insert a block into a table, you right click the cell and hover over "Insert." You'll see the option "Block." This will allow you to put a non-annotative block into the table cell. If you have a symbol that is annotative, what I do is in model space, I type "block" for a command, then I resave the block I have already created with a new name and make sure that I unclick "annotative." I hope that helps!
Following up on your thread, were you able to find a solution or a workaround? Did any of the posts in the thread help with the issue?
Please use the Accept as Solution for those post’s that helped. It may benefit other users who might have a similar question or issue.
Thanks for your time.
I have recently encountered the problem with insertion of annotative blocks. Although you have suggested a good workaround, I would be happy if AutoCAD would develop a permanent solution. I'll be using your method until they do. Thank you.
Can't find what you're looking for? Ask the community or share your knowledge.