How can I create a WAVE Dynamic Block?

[Anonymous]

Hello guys,

I would like to create a "wave" dynamic block, see below...

It is made from wipeout.

Is it chance to make a similar?

If I make a list for the length (from 125 to 350), after can I make a table /list /summary where these size are shown?

Please help me if you can!

Thank you!
T

[Anonymous]

guileful!
🙂

[Anonymous]

Could you help me an another dynamic block?

1.in the view "A" I dont know why does not draw the center line till the top of the anchor... 

What can be the solution?

2. Is it possibility to make a dynamic "C" view?

that the distance of the two stick at the view "A" will be the same on the view "C"?

please help me if you can!
Thank yo!
by T 

[ojuris]

check this

Juris

[Anonymous]

you are professional!
🙂
Thank you!

and my nex question if it is possible:

I made a "Block Propertiies Table" to my dynamic block.

It is working weel, but a litlle bit ugly... 🙂

You can see bellow.

How can I modify the list view? 
for exsample I dont need 30.0000 for me enough 30.

Thank you for your help again!!!!

T

[ojuris]

that problem You can solve with units settings, but it change settings not only for Block Propertiies Table, but whole drawing - Your decision what You prefer

Command: UNITS

Regards

Juris