Community

Editing one parameter calculates another and vice versa

Editing one parameter calculates another and vice versa

gert-leonvanlier
Collaborator Collaborator
190 Views
1 Reply
Message 1 of 2

Editing one parameter calculates another and vice versa

gert-leonvanlier
Collaborator
Collaborator
‎06-06-2023 07:03 AM

I couldn't think of a better title, so I hope I can explain it properly.

I have to create a dynamic block of a conveyor. This conveyor can be on every whole incline angle between -22 degrees to +22 degrees. The steps of the incline part is in steps of 100 mm. I am looking for a way to give in the start and end height of the conveyor and then the incline angle OR the length. So basically, the block should be able to calculate one of the other dimensions based on another.

 

Is there any way to get this done or am I asking too much of the dynamic blocks? In a previous job I would have used iLogic in Inventor.

0 Likes
Like
Report
191 Views
1 Reply
Reply (1)
Message 2 of 2

j.palmeL29YX
Mentor
Mentor
‎06-06-2023 07:11 AM

Post your file please. 

Jürgen Palme
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature

0 Likes
Like
Report
Report a website issue