Message 1 of 3

Not applicable
10-25-2016
11:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I was wondering if someone could help me figure this out or tell me what I am doing wrong.
The attached block is a décor partition. What I am trying to do is have the block to be able to stretch between 8'-0" and 13'-0" (accomplished) and at the same time have (1) of the angled slats added in (using the ARRAY action) every 4". I seem to be close but the ARRAY action is arraying (2) slats at once (every 8") when I only want (1) slat at a time to be added. Gaps between the header and a slat is okay as long as it is less than 4".
Make sense?
thank you
Solved! Go to Solution.