Announcements

Starting in December, we will archive content from the community that is 10 years and older. This FAQ provides more information.

Community
Dynamic Blocks Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Controlling the Display of Dimensional Constraints within block

1 REPLY 1
SOLVED
Reply
Message 1 of 2
maverick.b.jeske
368 Views, 1 Reply

Controlling the Display of Dimensional Constraints within block

Is there a way to turn of the dimensional constraints within a Block

 

There is an autocad page about this (link below), but I assume this only works using the parameter tab dimensional constraints. However since I've used the block editor tab, I can't seem to find a way to hide them.

https://knowledge.autodesk.com/support/autocad-lt/learn-explore/caas/CloudHelp/cloudhelp/2019/ENU/Au...

Basically it's starting to get a bit cluttered in my block and was wondering if I could hide them like the "DCDISPLAY" command. Any guidance would be appreciated.

 

1 REPLY 1
Message 2 of 2

I can't believe it took me so long, but I just figured I could just turn the 0 layer off instead of just trying to focus on hiding the dimension constraints. Although this is not entirely a great way of doing it. It works. Keen to still hear other ways, it anyone else has a better idea. 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

AutoCAD Inside the Factory


Autodesk Design & Make Report