DWG Trueview 2014 and ThinApp 5.2

[Anonymous]

Hello,

I created a thinapp package for Trueview 2014. It start ok en works fine. But... When I start a .dwg file from within the package (bubble) it opens directly and i see the drawing.

When I start the same .dwg file from outside the package, it start Trueview but stops at the start screen, where i must do File OPen and browse the specific .dwg file. So it does not show me the drawing directly. I tried the /nologo switch but that does not help.

Anyone here, who has some experience with this?

You can send answers also to [email protected].

Thanks for your help.

[pendean]

DTV is not supported in (or designed for) that setup.

[Emmsleys]

Following up on your thread, were you able to find a solution or a workaround?

Did any of the posts in the thread help with the issue?

Thanks for your time.