Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fillet after patch

1 REPLY 1
SOLVED
Back to Fusion Category
Back to Topic Listing
Reply
Message 1 of 2
kimberly.bigos
Explorer
216 Views, 1 Reply
‎02-18-2017 02:25 PM
‎02-18-2017 02:25 PM

Fillet after patch

I created a vessel in Sculpt mode then patched the bottom, it will not allow me to select the edge to do a fillet at the bottom.

Preview file
734 KB
Report
0 Likes
Reply
1 REPLY 1
Message 2 of 2
HughesTooling
Consultant
in reply to: kimberly.bigos
‎02-18-2017 02:33 PM
‎02-18-2017 02:33 PM

Have you stitched the surfaces together?

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


Report
0 Likes
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

Report a website issue