Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Extrude ShortCut differences in Patch Mode

2 REPLIES 2
SOLVED
Reply
Message 1 of 3
luvmesweet
245 Views, 2 Replies

Extrude ShortCut differences in Patch Mode

In the Patch Mode, pressing the shortcut "e" will bring up an Extrude Command Box but it does not extrude the curve. That is screen shot1. But using the Search Box Shortcut "s" and searching for "e" will bring up an Extrude command box that is the same as selecting the Extrude from the drop down menu. This Extrude Command can Extrude the curve projected to a surface. That is screen shots 2 and 3. So can you either improve the short cuts so they can match up the different modes or cancel the Shortcut "e" in the Patch Mode? 

 

1 Pressing short cut "e" brings up this Extrude Command Box that does not extrude the curve on the surface.

Screen Shot 2015-11-19 at 1.41.09 PM.png

 

 

 

2 Pressing "s" and searching for "e" brings up a different Extrude command box, which is the same as selecting "Extrude" from drop down menu. This Extrude can extrude the curve projected to the surface from another curve above this solid plane:

 

Screen Shot 2015-11-19 at 1.42.16 PM.png

 

 

 

3 The finished Illustration

 

Screen Shot 2015-11-19 at 1.42.30 PM.png

 

Thanks!

Best regards,
Kingson
2 REPLIES 2
Message 2 of 3
Phil.E
in reply to: luvmesweet

luvmesweet,

 

Thank you for this excellent report. Your text and images helped greatly to investigate and get this bug reported. I'm sure it will help the developer to be able to refer to this report. Well done!

 

The internal report number is FUS-21157.

 

Best regards,





Phil Eichmiller
Software Engineer
Quality Assurance
Autodesk, Inc.


Message 3 of 3
luvmesweet
in reply to: Phil.E

Dear Phil, thanks!
Best regards,
Kingson

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report