Community
Hey guys,
The Chain Select doesn't work:
Cheers / Ben
---------------------------------------------------------------------------------------------------------------------------
Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.
Check out my YouTube channel: Fusion 360: NewbiesPlus
Ben Korez
Owner, TESREG.com & Fusion 360 NewbiesPlus
TESREG - Fusion 360 Hardware Benchmark
Facebook | YouTube
I was going to write, "Chain select only works if the surface join is a tangent or smooth" but I found if you select an edge it will select all joined surfaces. See screencast.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
It's a nice Tip, but that's not what Chain's means 😉
It shouldn't matter where you click is should take everything. Else, they should change it to "Chain Select" but only if you click on an edge!
It shouldn't matter where you click is should take everything. Else, they should change it to "Chain Select" but only if you click on an edge!
Ben Korez
Owner, TESREG.com & Fusion 360 NewbiesPlus
TESREG - Fusion 360 Hardware Benchmark
Facebook | YouTube
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")