"Lifting feed plane to topmost ramp" problem

[michaeljcobb]

Can anyone help me out with what I'm doing wrong in the 2D Pocket1 toolpath in Setup1?

http://a360.co/2izwGBV

[Steinwerks]

I'd bet money it's your Ramping Clearance Height in the Linking tab. Cut it in half and see if the error goes away.

[michaeljcobb]

Thank you for this reply.  My apologies for not marking this as a solution.  It may very well be.  I wound up receiving some alternate strategies for constructing the toolpath that seem to have avoided the problem and improved my workflow.  

[michaeljcobb]

I did eventually figure out what was going on and it related strongly to what you were pointing out.  Thank you.