Community
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Turnout dimension Profile label Unable to mark dimension to full length of Turnout in profile

Turnout dimension Profile label Unable to mark dimension to full length of Turnout in profile

Dimension line->End point anchor point-> Rail Turnout end dimension is  pointing to CM, which is middle of turnout , Which shall be modified to point the JT_Main (end of triangle).

Dimension line->End point anchor point-> Rail Turnout middle shall be modified to point the CM (Triangle start point)Which will enable user to mark dimension the entire length of Turnout.

And, dimension distance not showing full length of Turnout. Length shown in below image 9.902 is no the full length of turnout, which 24.804 as per the DIMHOR

Ref:-

Krishnamoorthy_Ramanujam3RD7L_2-1707908004775.png

 

Krishnamoorthy_Ramanujam3RD7L_3-1707908156567.png

 

 

 

3 Comments

This IDEA shall be closed.

By selecting Appropriate Start point and end point, I am able to mark the dimension for length of turnout.

Krishnamoorthy_Ramanujam3RD7L_0-1708433249769.png

 

TimYarris
Autodesk
Status changed to: Implemented

Thank you for confirming, @Krishnamoorthy_Ramanujam3RD7L . I'll close this idea.

replyT8AGF
Community Visitor

Your idea has the potential to make a real difference, thank you for sharing it. Liteblue

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Answer Day

Rail Community


Autodesk Design & Make Report