Windening behavior in curves

[jochemZMHQ7]

Hi all,

I have a question about the widening behavior in curves:

I am designing a road where the width has to transition from 5meters to 4.8meters, over the lenght of a curve.

I did this by apllying a widening on the offset alignments. But it makes the curve all blocky (see image). It is not just a visual thing, because the corridor targeting it gets all blocky as well.

Is there a way to make this more smooth? I have been looking for a mid-ordinate-distance somewhere, but have not found one in the alignment or widening properties.

Any work-arounds are welcome too.

Thank you in advance!

Sincerely,

Jochem

[tcorey]

Increase your Frequencies through the curve.

[jochemZMHQ7]

Thank you for replying Tim.

Increasing the frequencies does not work, as shown below.

The problem is in the widening, not in the corridor.

Sincerely,

Jochem