Two superelevation in one pkt

[Anonymous]

Hello,
I made pkt for whole road and I have Lane and Shoulder in this model.
So I have question: How make two superelevation for Lane and Shoulder to pick each other in Civil 3d for example Outside Shoulder superelevation for Shoulder?

[Jeew-m]

It should be possible to add two types of superelevation on to your SAC.

Please check this video.

https://www.youtube.com/watch?v=ZEVzggF5vBg&list=PLjsw5HrA4MXn0qTwXCASOBlnYeG2jN8KI&index=5&ab_chann...

[Anonymous]

Thank you for answer.
I know this clip but there is one input parameter for superelevation.
So I have sth like than when I try put another one for my shoulder.

So I can't hae two superelevation parameters. I can set my shoulder superelevation from None to Right Shoulder superelevation but it always be just for right so what if I will set my subassembly for left too.
And what I did wrong, cause I got sth like that with next layer of my Lane.
I set AOR and it's not working.

I would like make sth like that:
With Shift Width and Edge Slope

[M_Obradovic · Accepted solution]

Hi janekbober90

Please see attached pkt file. Inside you have variable for define superelelvation for Right Lane and Shoulder and Left Lane and shoulder. If You have any question please ask. Hope this will help