Surface using existing slope values

[balkrishna_mahamuni42]

Hi,

I have this attached file received as input from site which only shows horizontal and vertical slopes of the parking stalls and I have to create surface from it. I start with one corner assuming it as a 0 level and work my way to the other points by doing sloped feature lines. however sometimes I end up with this values not tying with each other at another corner, because they do not provide cross slopes. I appreciate if anyone could provide me an idea how can I translate this information into a civil 3D surface which would nearly not exactly show these grades. 

Thanks,

[Elina.P · Accepted solution]

Hi @balkrishna_mahamuni42!

Thank you for your question!

This was one of the Civil 3D forum challenges posted a few months ago. Check out this topic for some workflow ideas:

https://forums.autodesk.com/t5/civil-3d-challenge/c3dchallenge-3-grading-parking-lot-may-16-may-28/t...

Remember to mark your posts as having an "Accepted Solution" if a solution is found, as it helps other forum users with the same issue – so don't be shy about marking it as a solution! Accepted solutions get viewed more and help more users find the answer to their problems.