Surface is not getting built properly using Breaklines

[aniruddh_ab]

I have built half of the surface of the FG surface using the corridor (road) by utilizing links/points code.

Then I built the other half surface (curb region surface) using breaklines which is a different surface.

Then I merged it as one surface (FG).

The surface is following the breakline irregularly (basically the surface top should be built by connecting breaklines). But here the breaklines are connecting to form a surface in a zigzag manner.

Unable to edit the surface using "Add Line" or "Swap Edges".

(I have attached a image, please check for better understanding)

[Dexterel]

Hello,

Have you try using only links and overhang correction? If you get the same result can you upload the dwg?  I can help you marge the surfaces.

 

[jroot]

Make sure the breaklines do not overlap the corridor surface.

Why not add the breaklines to your Corridor surface? Is there an advantage to having 2 surfaces and merging them?

[nguyenlehoang.cj]

I think you should adding the breakline by "Target" function (target the width and elevation) to road corridor. It better than build 2 surfaces then merging.