subassemly import civil 3D

[gogita.bolqvadze1]

hello I have imported subassembly in civli 3D and my problem is the section is not on daylight as shown in attached photo, I hope someone will help me

[michal.holda.]

Hi @gogita.bolqvadze1 , 

Could you please clarify a bit more what exactly is the issue? Could you please provide steps that you are following and what would be the expected result?

[RonaldBrañez]

Hi
1. Does the custom subassembly have the daylight code assigned at a single point?

If the answer is yes, the next question is
2. Does the assembly have the custom subassembly on both sides (Left and Right)?

If the answer to the first question is: "NO, there is more than one point with the same code in the subassembly", then you should know that civil 3d will not recognize the code for boundaries, since there should only be 2 points with the same code. in an assembly to allow it to be used as a boundary.

If the answer to the second question is: "NO", then code uniqueness is true, civil 3d requires only 2 points with the same code in an assembly to use it as a Boundary