Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Subassembly slope to surface not work

5 REPLIES 5
Reply
Message 1 of 6
Ramin-AZ
685 Views, 5 Replies

Subassembly slope to surface not work

Why the link does not connect to the surface

 

 

5 REPLIES 5
Message 2 of 6
M_Obradovic
in reply to: Ramin-AZ

Hi aramia436,

Sometimes if corridor section not follow sample lines chainage, in section view missing some lines. As option try to add corridor section on each sample lines as you can see on attached pictures.

Untitled.png

Hope this help

Message 3 of 6
Ramin-AZ
in reply to: M_Obradovic

thx for answer,I added chainage of section to the corridor, but it didn't work

Message 4 of 6
jroot
in reply to: Ramin-AZ

It looks like there are no subassemblies that target a surface.  Either that or the target surface was not defined.

Message 5 of 6
M_Obradovic
in reply to: Ramin-AZ

Hi aramia436

I know this problem can be very frustrating, but it can always be solved in some way. If you put corridor section over each sample line and issue are still appear try to do following. Move a little each sample line as you can see on attached video.

 

Hope this can help you.

Message 6 of 6
Ramin-AZ
in reply to: Ramin-AZ

I made another sub-assembly All sections were correct and there was no need to move the sample line and I set the corridor frequency to 100 Now the problem is from the 0+000 section and Should not use slope to surface

 

 

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report