Subassembly for roadway CL when roadway CL is not the roadway alignment?

[Anonymous]

Hi all,

I was hoping to receive some guidance on an issue I'm unfamiliar with. I have a roadway alignment I'm using to build a corridor, which will also be the construction baseline in the field. The problem is this roadway alignment is not the centerline of the roadway and the proposed roadway width varies, so my assemblies are targeting the alignment and not the true centerline of the roadway. Is there a subassembly I can use that will target the centerline of roadway, as well as left and right widths?

Thanks.

[wfberry]

Change your alignment to follow the center line of the roadway.

Bill

[Joe-Bouza]

Use the alignment and create the assembly as an offset assemly

[Jeew-m]

Dear Friend,

In addition to the JOE's comments I hope you can use two subassemblies; one to target CL and the other to target widths. 

However from the image it seems like the alignments are crossing each other. If that is the case you may need several assemblies and corridor regions.

Thanks