sub assembly is missing alternately

[dilsmails]

Hi all

I have an issue with sub assembly creating the corridor. The problem is where ever I am giving the offset target on that particular area sub assembly is missing alternately. But all cases are not similar, sometimes its on the left side and some other time it is on the right side. Somebody please help me to solve this issue.CASE-1CASE-2

Thanks

DK  

[Jeew-m]

Hello dilsmails,

It is better if you can upload a sample dwg.

At a glance it seems like the daylight is missing. But you show some widths are also not visible.

Try to make some sections views or go to section view editor and check where the problem exist.

Thanks

[dilsmails]

sample drawing is attached for your reference. could you please check and identify the problem  

Thanks

DK

[dilsmails]

Where ever the cross section is correct, on that location datum surface is not getting correct

[matthew_schwartz5CELZ]

Your subassembly is missing targets. Those need to be coded in through Subassembly Composser. 
LaneSuperelevationAOR has width, offset, slope or elevation targets.
Subassembly.Pave_Type_1To6 doesn't have any. So it's just going to do a sweep of the subassembly along your baseline. The only targets in there are in the BasicSideSlopeCutDitch.