Reversed Contour Lines on Corridor Surface

[qknopikMTBDM]

I inadvertently reversed the direction of my contour lines for the top of my paved road surface. I remember messing with a setting but can't find it again, it was a check box option that had "reverse" somewhere in it. I know it was Not reverse alignment. See the attached pictures, the cross section view looks "correct", the plan view is wrong on the street, the contour lines should be flip flopped. Thanks

Capture2.JPGCapture1.JPG

[n_bartholomew]

Hi there,

Just wondering what you are meaning by the contours flip-flopped? Could you give us all an example of what should look like, versus what you have uploaded already? (A simple sketch will do.)

Use the STATIONTRACKERALL command to get a better gauge of where your alignment and profile view lie in relation to each other at each station. I say this as it might indeed have reversed the alignment direction, and this will allow you to see it easier, if this inadvertently happened.

Please check that you have rebuilt your corridor (or it is set to automatically rebuild).

If that is all fine, please check your corridor properties and make sure that you are using the correct assembly set at the right station range.

Please mark this response as "Accept as Solution" if it answers your question.