profile link at intersection

[CADmgrMike]

I used the corridor intersection wizard to link two intersecting profiles together at the intersection point.

(I haven't created the intersection with assemblies yet. (A different learning session)

One of my alignments changed so now PI of the profile is not at the intersection point, but it's locked.

Is there a way to change the station of the PI?

Or do I need to delete my intersection and start over?

Not a big deal, but would be nice if I could just move the PI.

[Joe-Bouza]

Move the secondary alignment to intersect again

[CADmgrMike]

the alignments still intersect.

It's just that one alignment got longer at the beginning so know the station point where the two profiles intersect is different.

Ex:

Before: profiles intersected at Sta 10+00 on one alignment and Sta 14+00 on the other

After: profiles intersect at Sta 10+00 and Sta 14+10

the locked PI of the one profile is still at Sta 14+00 and I'm trying to figure out if I can move it to Sta 14+10.

[Joe-Bouza · Accepted solution]

Just delete an do over

[CADmgrMike]

Kind of what I was thinking.