Hello Everyone,
I am trying to create a Pressure Pipe from a 3D Polyline using the "Create Pressure Pipe From Object" command.
The vertices of my 3D Polyline have the correct elevation data. At the moment of creating the pressure pipe, I am using the "Use vertex elevations" option.
However, my network is being created at elevation 0.
Any suggestions on how to address this issue? Thank you very much.
How are you checking the elevation? Also, have you set the view to Isometric to see if the pipe is following the 3D Polyline?
Hi Vincent !
I am checking my 3d Polyline using properties panel, looking for my vertex elevations, as presented below:
I have checked the problem in Pressure Pipe Profile View, and you can also see it here using my object viewer, were you can notice my 3d polyline (white) in elevations around 800m and my pressure pipe (green) around 0 elevation
