Problem with cross sections and sample line

[h.castrocelani]

Hello everyone,

I am working on a project where I pulled some pipes´ cross sections using sample lines. Each of those show the pavment´s layers, existing gorund and the pipe. The problem comes when I slightly move the sample line, which goes all along the pipe, all the information attached to it just disappear.  

I have tried to delate and re add the information from the option "Sample more souces" but no success at all.

If anyone has happened to have the same problem I would higly appreciate the help!

Thanks!

[Jeew-m · Accepted solution]

Try to add a custom frequency line to the corridor at the new sample line location.

[h.castrocelani]

I am pretty sure that worked well since I have not encountered the problem again.

Thanks for your reply!